Inlet manifold
-
- Posts: 63
- Joined: Mon Sep 08, 2014 12:22 pm
- Location: Colac Victoria Australia
Inlet manifold
Spent a couple of hours removing rotted out heat exchanger pipe and bronzing in a new piece of pipe. Ready to go again. Will give it a clean and some paint.
Re: Inlet manifold
That's weird, I had to fix the other side of the Carb manifold block on Lurch a few weeks ago... Wonder why yours went on the left hand side and mine went on the right hand side - would have expected them to fail in the same place, either left hand side or right hand side!
Still, at least your one stayed nice and straight, my one end up being at a slight angle and so I altered the other part of the pipe, rather than have to arrange to make use of Julian's Oxyacetylene kit again.
John
Still, at least your one stayed nice and straight, my one end up being at a slight angle and so I altered the other part of the pipe, rather than have to arrange to make use of Julian's Oxyacetylene kit again.
John
Haflinger 703AP LWB 1973 - (Once owned by Lady Sutherland & Sons.) Now called "Lurch" !
Have you hit the "DONATE" button at the bottom of the page after reading this post? Many thanks if you have!!
Have you hit the "DONATE" button at the bottom of the page after reading this post? Many thanks if you have!!
-
- Posts: 146
- Joined: Sun Dec 30, 2012 11:27 pm
- Location: Ontario, Canada
Re: Inlet manifold
He's in Australia so the other side fails
--------------
72 Pathfinder Hafi
75 710M Pinzgauer 2.7i
96 350GDT
72 Pathfinder Hafi
75 710M Pinzgauer 2.7i
96 350GDT